Buick ManageUPS Manual de usuario descargar pdf (Pagina 8)

Installation

ManageUPS

NET

User Instruction Manual 5

Installation

This section will take you through the process

of installing the ManageUPS

NET

in the

interface slot of an ON Series UPS.

NOTE:

Shielded 10Base-T cable should be

used for both internal and external versions of

manageUPS.

Physical Installation

Internal Adapter

To install an optional interface card in an ON

Series UPS:

1. Shut down all UPS-powered systems. Turn

the UPS OFF and unplug it.

NOTE:

The ON3300 and ON5000 Series UPSs

have two power switches, one on the front and

one on the back. Be sure both are in the “OFF”

position.

2. Identify the interface slot on the back panel

of the UPS. Remove the plate if the UPS

does not have an interface card. Set the two

screws aside. The plate will not be used.

NOTE:

This slot may already have an interface

card in it. If so, carefully remove it to make room

for the new interface card.

3. Carefully slide the interface card into the

UPS guide rails. Reinstall the plate screws.

Figure 1. ManageUPS

NET

Adapter Installation

Overview

Auxiliary Interface Port

ManageUPS

NET Adapter

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 66 67

Sin comentarios

Buick ManageUPS Manual de usuario Pagina 8