Buick ManageUPS Manual de usuario descargar pdf (Pagina 24)

File Transfers

ManageUPSNET User Instruction Manual 21

Upgrading Firmware Firmware File Description

Firmware is the software running inside the

ManageUPS

NET that allows it to monitor the

UPS and perform all of the tasks described in

this manual. The ﬁle that is uploaded to the

adapter is actually a compressed ﬁle containing

the ﬁrmware ﬁle. This ﬁle is then

decompressed, validated and then written over

the ﬁrmware currently running on the adapter.

Obtaining the latest Firmware File

To obtain the latest ﬁrmware for your

ManageUPS

NET contact ONEAC Technical

Support (see Technical Support, page 3).

Upgrade Using FTP

The following steps should be taken when

updating the ManageUPS

NET using FTP.

1. Obtain the latest ﬁrmware (for example

ﬁrmware260x.gz) from ONEAC and place

it in a directory named \Manageupsnet on

your PC. The PC must be connected to the

network.

2. Ensure that the adapter is also attached to

the network and has already been

conﬁgured with an IP address, Subnet Mask

and a Default Gateway. The FTP server

must also be enabled.

3. Open a Command Prompt. Change to the

\Manageupsnet directory containing the

latest ﬁrmware ﬁle.

4. Open an FTP session by typing “ftp” at the

command line.

5. Connect to the ManageUPS

NET by typing

“open xxx.xxx.xxx.xxx yy” where

“xxx.xxx.xxx.xxx” represents the IP

address of the ManageUPS

NET and “yy”

represents the FTP server port. If the port

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 66 67

Comentarios a estos manuales

Sin comentarios